Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
Our Jonesboro, ME drying plans start with thermal imaging to map exactly where moisture is hiding.
We calculate drying requirements using temperature and humidity data, not a flat per-room rule.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
You receive documented daily readings showing the structure actually getting drier.
Here's the full scope of a Structural Drying And Dehumidification job in Jonesboro, from initial scan to final verification.
The assessment sets the baseline every later reading gets measured against.
We map the full extent of moisture intrusion before placing a single air mover.
We position air movers to create directed airflow across wet surfaces based on the assessment.
A technician returns daily to take moisture readings and log progress against the drying plan.
Hardwood floors and built-in cabinetry require slower, more controlled drying to avoid warping.
Final verification compares closing readings against the material-specific dry standard, not a general guess.
Tell our Jonesboro, ME dispatcher about the current condition so we can prepare the right diagnostic equipment.
A technician arrives with thermal imaging cameras and moisture meters ready to assess.
We complete the psychrometric assessment and thermal scan, then provide a written drying plan and quote.
We verify final moisture readings against dry standard before removing equipment.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
A room can look dry on the surface while moisture meters still detect trapped moisture inside materials.
It's the technical foundation behind Structural Drying And Dehumidification rather than a marketing term.
Timeline depends on material type and how much moisture the thermal scan revealed.
You'll see the actual numbers improve each day through documented logs.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
A stall in the daily logs triggers a plan review rather than simply leaving equipment running unchanged.
If your property is in or near Jonesboro, a crew can typically respond the same day.
One call starts the psychrometric assessment process.
Call +1-844-833-1325